Azzera filtri
Azzera filtri

Addon Library for Adafruit 16-channel 12 bit PWM servo driver with Arduino use

20 visualizzazioni (ultimi 30 giorni)
I am wondering if it is possible to use a 16 channel PWM board for matlab to Arduino to I2C connection. I am aware of the 2 channel PWM capacbilities of the "Adafruit\MotorshieldV2" servo library. I am writing to understand if it is possible to use a 16 channel Adafruit PCA9685 board with matlab? I believe the two boards use the same chip but I am unsure how to implement this.

Risposte (1)

Aditya il 17 Apr 2024
It is feasible to use MATLAB to control devices over an I2C connection with an Arduino and a 16-channel Adafruit PCA9685 PWM/Servo driver board. The PCA9685 may be interfaced with MATLAB via an Arduino and is commonly used for controlling multiple PWM outputs, such as servos or LEDs.
While MATLAB's support packages allow direct communication between Arduino and many shields, you may need to develop or modify code in order to enable communication between MATLAB, the Arduino, and the PCA9685 board for more specialized hardware, such as the PCA9685.
You'll need to upload a sketch to the Arduino that initializes the I2C communication and sets up the PCA9685. Adafruit provides an Arduino library for the PCA9685, which you can use to control the PWM outputs.
  • Install the Adafruit PCA9685 library in your Arduino IDE.
  • Write a sketch that includes initializing the PCA9685 and setting PWM values. For direct control from MATLAB, you might start with a simple loop that reads serial commands to set PWM channels.
With the Arduino programmed to communicate with the PCA9685 and listen for commands (e.g., over serial), you can now send commands from MATLAB.
  • Initialize Serial Communication: Use serialport in MATLAB to open a connection to the Arduino.
  • Send Commands: Write functions in MATLAB that send specific commands over serial to set the PWM values on the PCA9685. The Arduino sketch should parse these commands and set the PWM outputs accordingly.
Here's a very basic example of how you might start this in MATLAB:
% Example MATLAB code to send PWM commands to Arduino
% Replace 'COM3' with your Arduino's serial port
arduinoSerial = serialport('COM3', 9600);
pause(2); % Wait for connection to establish
% Function to set PWM channel and value
function setPWM(serialObj, channel, value)
commandString = sprintf('SET %d %d\n', channel, value);
write(serialObj, commandString, "string");
% Example usage: Set channel 0 to a PWM value of 1024
setPWM(arduinoSerial, 0, 1024);
% Clean up
clear arduinoSerial;


Scopri di più su Instrument Control Toolbox Supported Hardware in Help Center e File Exchange

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by