Three-Phase PI Section Line Parameters
4 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
For the model that I am building I do not have access to zero-sequence impedance values for the conductors that I am using. Am I right in assuming that this will not affect my load flow and simulation results? Is there any way to calculate these values?
Thank you, Kyle
0 Commenti
Risposte (1)
Joel Van Sickel
il 18 Ago 2021
Hello,
as part of an effor to clean up matlab answers, this response is being made even though it is far too late to be of use to the asker:
You can ignore zero-sequence to get a basic idea of how your system will perform, especially if it is balanced, however, instead of leaving it at zero, you might consider making the same as your positive sequence (or a bit smaller) This is not ideal however. There are tools to help estimate these parameters if you know your conductor's geometry.
Regards,
Joel
0 Commenti
Vedere anche
Categorie
Scopri di più su Simscape Electrical in Help Center e File Exchange
Prodotti
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!