How to switch uitab using commands?

5 visualizzazioni (ultimi 30 giorni)
Albert Bing
Albert Bing il 11 Mag 2022
Commentato: Albert Bing il 11 Mag 2022
I wrote a GUI program and needed to switch uitabs. Is it possible to switch to next uitab using command? Suppose I had 2 axeses, ax1 & ax2, axis(ax2) would switch to ax2, so how to switch uitab using commands?
If not possible, how to send a shortkey in MATLAB? If I can send a shortkey "ctrl+tab" using a command, it will do the uitab switching job.
P.S. the program uses figure, not uifigure.

Risposta accettata

cr
cr il 11 Mag 2022
Modificato: cr il 11 Mag 2022
Use SelectedTab property of uitabgroup.
E.g.
f = figure;
tabgp = uitabgroup(f,'Position',[.05 .05 .3 .8]);
tabA = uitab(tabgp,'Title','Tab A');
tabB = uitab(tabgp,'Title','Tab B');
tabgp.SelectedTab = tabA; % Switch to tab A
tabgp.SelectedTab = tabB; % Switch to tab B
Regards
  1 Commento
Albert Bing
Albert Bing il 11 Mag 2022
Ah, it's a property of uitabgroup, a litttle like the case in uibuttongroup.

Accedi per commentare.

Più risposte (0)

Categorie

Scopri di più su Migrate GUIDE Apps in Help Center e File Exchange

Prodotti

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by