PX4 firmware upload error

I'm having this error while trying to configure the UAV Toolbox Support Package for PX4 Autopilots with my Pixhawk 2.4.8 board.

The following error occurred during deployment to your hardware board: 
Firmware upload failed with the following error:
 Loaded firmware for board id: 9,0 size: 918596 bytes (88.99%), waiting for the bootloader...


Found board id: 9,0 bootloader version: 5 on COM4
sn: 002700333235510e34363339
chip: 20016419
family: STM32F42x
revision: 3
flash: 2080768 bytes

ERROR: Board can accept larger flash images (2080768 bytes) than board config (1032192 bytes). Please use the correct board configuration to avoid lacking critical functionality.

[Shiva Shankar]

i also have the same error some one can find the solution please

[Shiva Shankar]

i got it ...

select "make px4fmu-v3_default" in the hardware setup screen .. then continue ...with remaining setup....

Answer 1

[Shiva Shankar]

before generating the firmware ....

select "make px4fmu-v3_default" in the hardware setup screen .. then continue ...with remaining setup....

[John conner]

in matlab 2023b we dont have any other option. we have to choose v5.

it works without any problem in my laptop which is connected to internet.

but i cant complete uploading firmware into another one which is stand alone.