How to use I/O mode to control a servo motor?
2 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Hello everyone, I am learning to use Arduino to control a servo motor. I successfully realized the this model, using external mode(run on the board), and the motor worked well. However, if I switch to I/O mode(run on the computer), the motor won't move at all. What other settings should I do?
I have another program that is too large to run on the board, so I want to try I/O mode first in this simple example. Any reply is welcomed. Thank you!
0 Commenti
Risposta accettata
Arun Kumar
il 3 Giu 2022
Hi Cong Sun,
Not all the block support connected IO mode.
The blocks that support this IO mode are listed in the following page:
Other blocks which are not listed in this page will output 0s if you try to run in connecte IO mode.
Hope this helps!
Thanks,
Arun
6 Commenti
Arun Kumar
il 24 Giu 2022
Hi Cong Sun,
Changing of PWM frequency is not supported in Connected IO mode.
Più risposte (0)
Vedere anche
Categorie
Scopri di più su Arduino Hardware in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!