Print figure into report
7 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Hi,
I'm trying to design an app that will run a few simulations and output the results in the form of a PDF. I've managed to sort out all other issues, but to plot my graphs into the report, I'm using the following method. (I went through many methods from MATLAB Central, and this is the one that worked and so I went forward with it.) The issue I'm encountering is line #9 pops up a figure and plots the graph onto it, before printing it into the report. And since I'm plotting close to 12 different graphs, this can become annoying for the user of the app. Are there any workarounds for this?
for kk =1:5
if app.test_selected==2
plot(app.x.(sprintf('SR%d',kk)).time,app.x.(sprintf('SR%d',kk)).velocity);
hold on;
elseif app.test_selected==3
plot(app.y.(sprintf('SR%d',kk)).time,app.y.(sprintf('SR%d',kk)).velocity);
hold on;
end
fig17=Figure();
fig18=Image(getSnapshotImage(fig17,AccGradeTestReport));
end
hold off;
add(Chapter2,fig18)
2 Commenti
Risposte (1)
Yatharth
il 6 Lug 2022
2 Commenti
Adam Danz
il 11 Lug 2022
The figure needs to be generated before it can be embedded into the report. However, it could be generated with visibility set to off as was recommended below in the answers and then you could set visibility back on, if needed, before doing the report generation. I believe that's what @yatharth was getting at.
Vedere anche
Categorie
Scopri di più su Simulink Report Generator in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!