How to open Scope in Simulink with Matlab command?
40 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Mahdiyar
il 2 Apr 2015
Modificato: carlos vasquez
il 31 Gen 2017
Hi everyone
I want to run the simulink with the matlab command "sim". I need to see the trend of a signal . So, I use a Scope.
I want to open the scope with a matlab command line. Is there any way to open the scope in simulink with matlab command, not manually?
Regards
0 Commenti
Risposta accettata
Azzi Abdelmalek
il 2 Apr 2015
open_system('YourSimulinkModelName/ScopeName')
2 Commenti
carlos vasquez
il 31 Gen 2017
Modificato: carlos vasquez
il 31 Gen 2017
i use this comand but, when i want to use the command set_param(gsc,'Simulationcommand','Stop'). i have this error. subsystem block does not have a parameter named 'Simulationcommand'. also i use the comand close_param for close all but i have the same error. this command works on guide of matlab?
help
Più risposte (0)
Vedere anche
Categorie
Scopri di più su View and Analyze Simulation Results in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!