How to set time domain Simscape model to hours instead of seconds?
2 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
For my hydraulic isothermic model I model a centrifugal pump installation. Normally, flows and pump capacity characteristics are in m^3/h. However, in the centrifugal pump (IL) block I need to set capacity vector in m^3/s, and it does not recognize me changing it to m^3/h. This makes it more difficult than necessary, as I now need to change all other flow units to m^3/s. I cannot just act like seconds are hours, as I will then get problems with units as rpm (minute).
How do I change the flow to m^3/h?
0 Commenti
Risposta accettata
Più risposte (1)
Nikhil Muthakana
il 15 Mag 2023
Convert your m^3/h parameters to m^3/s by dividing the m^3/h value by 3600 (since 1 m^3/s = 3600 m^3/h)
3 Commenti
Nikhil Muthakana
il 15 Mag 2023
The blocks do not have the option of m^3/h (even in the Flow Rate Sensor block), so after converting the simscape physical signals to simulink data signals, use a gain block on the signal with 3600 as the value to convert the m^3/s to m^3/h when you log the flow rate signals. You can name the signals appropriately to keep track of the units.
Vedere anche
Categorie
Scopri di più su Model Statistics in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!