Why I get Nan values in when i connect an inverter into a 11kV grid feeder?
5 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Hello.
I have a simulink model with a power grid with 3 feeders in 11kV. In each feeder i have connected several load profiles and everything is working. When i try to connect a PV inverter on the feeder, i get 'Nan' at the output of the inverter (e.g., for voltage, active and reactive power etc). The inverter is connected through a transformer 11lV to 400V and a filter.
Something weird is that when i connect the inverter close to the source ( between the source and a load), i don't get these Nan values, while when connecting the inverter more away from the source, the Nan vlues appear.
Any idea why is this happening?
Thanks.
2 Commenti
Franklin
il 21 Set 2023
#Itemone #Itemtwo act or effect of amending, of rectifying a fault or defect; correction.
"e. to a book"
Walter Roberson
il 21 Set 2023
Risposte (1)
Sayan
il 25 Set 2023
Hi Eleni T,
I understand from your issue that you are using a "PV Array" block as a source to run the inverter in your model to feed power to your grid with the 3 feeders. However, the inverter output is 'Nan'.
The possible reasons for the issue and their fixes are mentioned below:.
- The “PV Array” block (available at Simscape / Electrical / Specialized Power Systems / Sources) has an internal algebraic loop that is not solvable for the sample time defined in the model to solve the ineternal non-linear diode characteristics of the block.
- The "Break algebraic loop in internal model" option in the "Advanced" tab of the “PV Array” block needs to be selected to break the algebraic loop.
If the above-mentioned solution does not work, you can follow these alternative steps to fix the issue.
- Verify that there is no division by zero operation in your model.
- Try changing the solver type and step size in your model.
For better understanding, you can refer the following MATLAB Answers post. A similar issue regarding the “PV Array” block is addressed in this post:https://www.mathworks.com/matlabcentral/answers/466337
You can further find more information on the "Break algebraic loop in internal model" section of the “PV Array” block in the following MATLAB documentation
Hope this helps in resolving the issue.
0 Commenti
Community
Più risposte nel Power Electronics Control
Vedere anche
Categorie
Scopri di più su Electrical Sensors in Help Center e File Exchange
Prodotti
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!