Using STM32CubeMX and Creating Global Init Functions

I have been intermittently attempting to use a Arduino Giga R1 with Simulink. I have, to my knowledge setup a simple example within a STM32 ioc file (derived from this setup: https://github.com/szabo-tamas/GigaR1Init). However in the building process within Simulink, it fails due to init functions needing to be set to global functions. I have followed all steps within the stm32cubemx guide on mathworks. Current information about how to set up in stm32cubemx: https://www.mathworks.com/help/supportpkg/stmicroelectronicsstm32f4discovery/ug/Getting-started-stm32cubemx.html.

Are there any guides on how to accomplish this appropriately or correctly within matlab/simulink environment, instead of what was recommended within the STM32 community here: https://community.st.com/t5/stm32cubemx-mcus/how-to-change-init-functions-to-global/td-p/53187. I drafted a simple function to update the init function-calls to be externs, not saying it couldnt be optimized, or improved (see attached). I believe this should enable building the simple example, however I still receive the same error when attempting to build code.

Current error when I attempt to build:

Every init function must be configured to generate a global function call instead of static functions call in STM32CubeMX project.

[Nithin]

The Arduino Giga R1 is based on the STM32H747XI, which is a dual-core based board. We currently do not support dual-core STM32 targets. It will be supported in future releases.

[Francis B.]

When may be the anticipated future release?

[Nithin]

STM32H7xx based dual-core boards are supported in R2024a and advanced peripheral support along with FreeRTOS and MATLABPIL is supported in R2024b as part of the Embedded Coder Support Package for STM32.

Answer 1

[Francis B.]

Dual core not supported

Answer 2

[Francis B.]

Asked here: https://www.mathworks.com/matlabcentral/answers/1935144-arduino-giga-r1-compatibility?s_tid=srchtitle

However seems incorrect.

Answer 3

[Mohamed Lamine]

Hello,

try this,

In the CubeMx > Project Manager > Advanced Settings, uncheck all the periph.

It worked for me.

good luck