USRP N210 Matlab Crash in Communications Toolbox (USRP)

During setup of a USRP N210 on MATLAB's Communications Toolbox Support Package for USRP Radio, the initial test failed on "Receive the signal and verify the frequency of the tone" field. Afterword, MATLAB crashed and my USRPN210's led's swapped from D&F to B & F. I also can't get a successful ping or find my USRP with 'uhd_find_devices --args="addr=192.168.10.2"' now.

Aside from the USRP manual showing LED 'B' as a MIMO cable link, I haven't seen anything stating that the B & F combination indicates any known error. Did I somehow brick my USRP? If not, is there something else I should know about troubleshooting from here?

Answer 1

[Shreeya]

Hello

From your question, I gather that you are unable to connect to the USRP Radio through the MATLAB's Communications Toolbox Support Package.

Ensuring that your computer's network interface is correctly configured to communicate with the USRP can be a good starting point. You can refer to the documetation below for this:

Configure Ethernet Connection Manually on Windows 10 for USRP Radio - MATLAB & Simulink - MathWorks India

Regarding the MATLAB Crash, it would be helpful if could share the crash log. Also, Trying to reinstall the required add-on might help.