Error encountered in the Deep Signal Anomaly detector while running the official SIMULINK example

Hi all,

I am runnining this official Simulink example here: fault_localization in 3-phase power line.

I had a somewhat different circuit and thus I trained a new model following this guideline. However, after training my deep anamoly detector and while trying to apply this trained model to my detection model, I keep getting this error as shown in this screenshot:

Any suggestions on how to fix this? I'm pretty sure I used the

saveModel

command to save the parameters of my trained model. It looks like the model parameters file in the provided example works here, but mine wouldn't work. I spent quite some time on this but still haven't figured out a solution.

Answer 1

[Divyanshu]

Hi Randy,

I tried to follow the example fault_localization and it is now throwing any error if I keep the names of the .mat files unchanged.

However, when I change the names of '.mat' file in the script as well as in the Mask of 'Deep Signal Anomaly Detector' block and rename it in such a way that the name contains some 'Non-ASCII' character then the exact same error is thrown as specified in the query.

Here are some troubleshooting steps which you can try:

• Ensure that the names of '.mat' files are same in the mask as well as when saving the trained network.
• Make sure that there are no 'Non-ASCII' characters in the name.

[Randy Chen]

that solved my problem, thank you!