Cannot Add Parameters - "Parameter is not floating point and will be cast to double"
101 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Dieter
il 21 Set 2024 alle 17:01
I am trying to use the sensitivity analyzer on a golf swing model I have that uses parameters from model workspace. Whenever I try and add parameters to the sensitivity analyzer. Whenever I try and add it says:
"The following parameter(s) are not floating point and will be cast to double: HipConstant"
After saying this it does not add the parameter and does not cast it to double. How do I change my parameters to floating point if that is in fact the issue.
I've tried going into the model workspace and changing parameter data type from auto to double and it doesn't change the behavior.
Edit: I've attached the model and input file to the question.
4 Commenti
Sreeram
il 24 Set 2024 alle 8:28
@Maven Euler: I fixed it by clearing the PreLoadFcn, and placing ModelInputs.mat in the same folder as the SLX file.
Risposta accettata
Sreeram
il 24 Set 2024 alle 8:28
Hi Dieter,
I also faced the same issue with the model you shared in MATLAB R2024a. However, I could successfully add the parameter in MATLAB R2024b. So, I recommend updating to MATLAB R2024b.
I hope it helps.
0 Commenti
Più risposte (1)
Vedere anche
Categorie
Scopri di più su Introduction to Installation and Licensing in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!