Mux to Bus error message

I'm getting a strange error when trying to run one of our models in simulink: I'm being told 'The block diagram 'Filename' uses bus signals. However, the 'Mux blocks used to create bus signals' diagnostic is not configured to 'error'. To prevent modeling errors:'

Why am I getting an error message for something I've deliberately turned off? Due to the way the model interfaces with our software it has to have a mux creating a bus otherwise it won't work so I can't replace the muxes with buses.

[Kevin Quigley]

You accepted the answer, but it's unclear if using the suggested setting solved your problem or it prevented you from using your model as implied in your question.

What was the outcome of setting this to 'error'? Did you have to rework the model?

Answer 1

[Vinod Sudheesh]

Hi Matthew,

To avoid this error please navigate to

Model Configuration Parameters (Ctrl+E) >> Diagnostics >> Connectivity >> Mux blocks used to create bus signals:

and set the value to "error".

Please note that this diagnostic needs to be set to "error" whenever there is a bus signal in the Simulink model so as to ensure that there will not be any problems with block connections while compiling the model.

Hope this helps!

Vinod

[Walter Roberson]

Sam Samat comments,

Great help for newbie

[Saif]

Great help, Thanks

[mouli thirumalasetty]

helpful thanks

[Kamal Ebrahimi]

THANKS A LOT

[yousef naghibzadeh]

thank you

[wang claude]

thanks a lot, great help

[Avinash Kishore]

Thank you. It helps

[MOHAMMED AL-MAHMODI]

Thanks

[Mujtaba Syed]

thanks man

Answer 2

[Gagandip Singh Khanduja]

Thank you for useful information