extractFeatures, reference to "Block"-method
1 visualizzazione (ultimi 30 giorni)
Mostra commenti meno recenti
Hi
I'm compairing the SURF- and the Block-method in the extractFeatures-function.
Is there any article which describes the Block-method which the Matlab implementation is built upon? Is it the same implementation as the "Block-matching method" in OpenCV? I can't find much (if any) information in the book "Learning OpenCV" which is referred to in the documentation.
0 Commenti
Risposte (1)
Alex Taylor
il 29 Dic 2011
I'm not sure about where to find a good reference at the moment, if you're looking for a paper, but if you look in the reference page for extractFeatures:
The description of block is:
"Simple square neighbhorhood. Note: The Block method extracts only the neighborhoods fully contained within the image boundary. Therefore, the output, VALID_POINTS may contain fewer points than the input POINTS."
In the example that is provided:
I = imread('pout.tif');
hcornerdet = vision.CornerDetector;
points = step(hcornerdet, I);
[features, valid_points] = extractFeatures(I, points);
They are using the default 'auto' method, which will use the 'block' method because the input points are Nx2 coordinates from the corner detector.
Block feature extraction just extracts small neighborhood blocks of the actual image data centered at the [X Y] locations specified in the point input. In this case, the extracted features blocks of the input image 'pout.tif' centered at corner locations.
Hope that helps.
Vedere anche
Categorie
Scopri di più su Computer Vision with Simulink in Help Center e File Exchange
Prodotti
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!