Why the 48 pulse GTO-Based STATCOM doesn't work effectively on my model?
3 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
This is my observed bus voltage in per unit before installing STATCOM.
However, bus voltage after installing STATCOM only increase reactive power level since there is still the same ripple. How can I eliminate the ripple on voltage? The setting in STATCOM is the same as follows: https://www.mathworks.com/help/physmod/sps/powersys/ug/gto-based-statcom.html
Thank you very much!
0 Commenti
Risposte (1)
Joel Van Sickel
il 2 Mag 2023
This is an effort to clean up Matlab Answers. Unfortunately, this response is likely to late to be of help to this question:
For this type of question, a model would need to be shared to better understand why a certain approach might not be working.
0 Commenti
Vedere anche
Categorie
Scopri di più su Power Converters in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!