??? In an assignment A(I) = B, the number of elements in B and I must be the same.
1 visualizzazione (ultimi 30 giorni)
Mostra commenti meno recenti
I have to write a program for school that can read the temperture in a rooftile dryingroom. A NTC will be connected to a data-acquiring card. but when I want to use formulas on the whole matrix this creates is gives the before stated error. Below is the relevant code (the last 2 lines produce the error):
...
s=daq.createSession('ni');
s.addAnalogInputChannel('dev1',0,'Voltage');
s.Rate=rate;
s.DurationInSeconds=tijdseenheid;
[data,time]=s.startForeground;
...
const_a=input('The value of consistant A: ');
const_b=input('The value of consistant B: ');
weerstand=input('The value of the resistor: ');
ubron=input('The value of the powersupply: ');
data(:)=((ubron-data)*weerstand)/data;
data(:)=const_b/log((data)/const_a);
...
1 Commento
Jan
il 12 Mar 2012
The error cannot be produced by two lines. Only one command can cause the error - afterwards Matlab stops.
Risposte (1)
Tom
il 12 Mar 2012
I'm not entirely sure what the variables are, but you may be meaning to do an element-by-element divide, not a matrix divide: in this case use ./ not / to divide.
2 Commenti
Jan
il 12 Mar 2012
You definitely need the elementwise operators. If you've tried this already without success, post your trials here.
Vedere anche
Categorie
Scopri di più su National Instruments Frame Grabbers in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!