Question about the "enable" block.
2 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Hi,
I have a little question about the enable block. If I have a enable block in a subsystem, what become my outputs when my subsystem is not enable ? And more specially when I have one output which is a bus ?
0 Commenti
Risposta accettata
Più risposte (2)
Arnaud Miege
il 18 Mar 2011
Have a read of Enabled Subsystems in the Simulink documentation, particularly the section Setting Output Values While the Subsystem Is Disabled. As far as I know, this works with busses as well.
HTH,
Arnaud
0 Commenti
Sébastien Malengé
il 18 Mar 2011
2 Commenti
Guy Rouleau
il 22 Mar 2011
Did you really read the section mentioned by Kaustubha? This is what you need. Note that it is available since MATLAB R2010a.
Kaustubha Govind
il 23 Mar 2011
Guy: I think Sebastien's reply was to Arnaud's answer. My answer came later but got voted up, so it shows up higher.
Vedere anche
Categorie
Scopri di più su Schedule Model Components in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!