Error while loading interface model of QPSK HW/SW AD9361 example interface model
1 visualizzazione (ultimi 30 giorni)
Mostra commenti meno recenti
In the factory configuration, toolchain cannot be set to "Xilinx Software Development Kit (SDK)" when 'Hardware board' is set to "Xilinx Zynq Based Radio Board Target". In the model configuration properties, above settings are present by default and I have not changed any of the configuration parameters. This error keeps occurring frequently. But on re-run, sometimes the model runs on the PICOZED hardware without any errors. How to resolve this issue?
0 Commenti
Risposte (1)
Emmanouil Tzorakoleftherakis
il 8 Gen 2018
Hi Vinay,
I am assuming you are referring to this example. Try following the steps under the "Setup" section in the link, i.e., reinstall the two support packages and run the configuration steps again to make sure everything is set up properly. If this does not resolve the issue, can you reply with the exact error that you are getting?
Vedere anche
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!