PIL simulation mode using LEGO EV3
1 visualizzazione (ultimi 30 giorni)
Mostra commenti meno recenti
Each time I run my model in PIL mode using LEGO EV3 I get the following Error. "The configuration parameters for this model do not support the following connectivity configurations: Raspberry Pi, Texas Instruments Code Composer Studio (IDE), Texas Instruments Code Composer Studio (TCP/IP), Texas Instruments Code Composer Studio (Serial)"
While the External mode is working very well.
0 Commenti
Risposte (0)
Vedere anche
Categorie
Scopri di più su LEGO MINDSTORMS EV3 Hardware in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!