why matlab hangs up when i use 2 channels from analog discovery with data aquisition toolbox
1 visualizzazione (ultimi 30 giorni)
Mostra commenti meno recenti
clear
s = daq.createSession('digilent')
ch = addAnalogOutputChannel(s,'AD1', 1:2, 'Voltage')
rate = 1e6;
s.Rate = rate;
outputData(:,1) = linspace(-1,1,1000);
outputData(:,2) = linspace(-2,2,1000)';
queueOutputData(s,outputData);
startForeground(s);
hi,
i whant to generate signals on two channels with analog discovery divice, with data aqisition toolbox. While using one channel there are no problems occuring. When i use two channels (with the code below) the signals gets generated, but then matlab dont stops running and i can unly quit when closing matlab.
I am very grateful for help
0 Commenti
Risposte (1)
Sai Deepesh Pokala
il 8 Giu 2018
When you install MATLAB, there is a cap on the RAM that it is allowed to occupy. Therefore, if your code involves creating temporary high-dimensional arrays or matrices, chances are it might reach that limit. Try eliminating unwanted loops or assignments. Good luck!
0 Commenti
Vedere anche
Categorie
Scopri di più su Data Acquisition Toolbox Supported Hardware in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!