Simulink model for DC shunt motor does not give correct output despite no errors.

3 visualizzazioni (ultimi 30 giorni)
Saiankita Anand
Saiankita Anand il 14 Ott 2018
Risposto: Sabin il 24 Dic 2024
The attached Simulink .mdl file (MATLAB 2017) contains a model for DC shunt motor. The DC motor block was cut and pasted from MATLAB 2014. The model runs but the output is not correct. Scope does not show plots for armature current vs speed, torque vs speed.
Help and suggestions appreciated.

Accedi per rispondere a questa domanda.

Risposte (1)

Sabin
Sabin il 24 Dic 2024
This seems to be a parameterization issue. Increasing the field resistance to 150 Ohm will enable simulation to a nonzero speed. The exact parameterization will depend on application requirements.

Community

Più risposte nel  Power Electronics Control

Categorie

Scopri di più su Motor Drives in Help Center e File Exchange

Tag

Prodotti

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by