Using the power electronic model based on the frequency response data to design the controller, the result is not correct.

Hello, engineer！

I used the power electronic model based on the frequency response data to design the controller routine with incorrect results.I follow the example steps, and the steady-state working point obtained is quite different from that given by the example. The resulting BODE diagram is not correct.I need help, thank you!Example name:Design "Controller for Power Electronics Model Using Frequency Response Data"

The working point on the left side in the above figure is given by an example, and on the right is obtained by software operation. The version I currently use is 2017B.

[Siddharth Jawahar]

Hi Jia,

I am not able to reproduce this on my end. Are you using the same model without any chnages?

Best,

Sid