meshing problems: How to control the triangles size and how to get the edges properly

2 visualizzazioni (ultimi 30 giorni)
I would like to mesh a 3d model into Matlab using data from a STL file, and I am facing two troubles in doing so.
1/ I would like to control the triangles / faces size.
2/ I am getting extra edges which obviously should not be generated and do not fit the 3D model (see figure attached 'femur.png')
Note: I am using the codes provided in ( and (
Thank you and best regards!

Risposte (0)


Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by