I have confusion in Simscape Co2 transcritical system example. How you had designed compressor i dont get it and why you used PS LOOK UP TABLE 2D IN COMPRESSOR. Do i need a specific date to run this

3 visualizzazioni (ultimi 30 giorni)
ASUTOSH JOSHI
ASUTOSH JOSHI il 22 Gen 2019
Risposto: Yifeng Tang il 21 Set 2022
I am doing simulation of CO2 transcritical system.

Accedi per rispondere a questa domanda.

Risposte (1)

Yifeng Tang
Yifeng Tang il 21 Set 2022
The 2D LUT and an ideal flow rate source is to represent the BEHAVIOR of a compressor. If the pressure ratio (outlet/inlet) rises, the flow rate drops, and if the compressor RPM increases, the flow rate increases. The 2D LUT basically describes these behaviors. If you plot flow vs pressure ratio at different RPMs, you'll get a figure of the compressor map.

Categorie

Scopri di più su Simscape Fluids in Help Center e File Exchange

Tag

Prodotti


Release

R2018b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by