"Selection for Simulink" Widget in IBM Doors NG

Hi

I am trying to establish bidirection link using Simulink Requirements between a Simulink model and the requirement artifact in Doors NG. One I added the "Selection for Simulink" Widget, there is a link that is supposed to direct to the Simulink model but never works. I wonder if there is anything to do for setup.

I also consult with IBM and they said this widget was developed by Mathworks.

Thank you very much

Tony

Answer 1

[Paul Urban]

To set up the integration wtih DOORS Next Generation follow these steps described in the help:

Configure RMI for IBM Rational DOORS Next Generation Interaction

This is a one time setup. Remember to run MATLAB as administrator when doing the rmi setup.

This help topic describes linking to DNG: Requirements Traceability with IBM Rational DOORS Next Generation

[MD Nawaz]

Hi,

Iam trying to integrate IBM DOORS Next Gen with simulink by following document https://in.mathworks.com/help/slrequirements/ug/requirements-traceability-with-ibm-rational-doors-next-generation.html#mw_20a5b8d4-09b4-4d7c-8ed8-b28a278b90f5

But i was unable to perform steps i.e. configure RMI Configure RMI for IBM Rational DOORS Next Generation Interaction in document https://in.mathworks.com/help/slrequirements/ug/configure-rmi-for-ibm-rational-doors-or-microsoft-activex-navigation.html#

and even i couldnt find the folder "slrequirements" in my matlab installation folder (eventually to get dngllink folder) for Install the Simulink Requirements Widget in IBM Rational DOORS Next Generation.

please provide insights for above queries

Thanks in advance,

Nawaz

[steve steve]

slrequirements is part of the Requirements Toolbox install

[Paul Urban]

That is correct that Simulink Requirements needs to be installed. If it is then you may want to contact support for assistance on the installation with DNG https://www.mathworks.com/support/contact_us.html?s_tid=sp_ban_cs