how to control dc motor by matlab gui with adafruit motorshield V1?

4 visualizzazioni (ultimi 30 giorni)
please help to control dc motor by matlab gui with arduino adafruit shield V1

Risposte (1)

Tony Lennon
Tony Lennon il 9 Ago 2019
It's not exactly the same HW setup, but close.
  2 Commenti
amin ya
amin ya il 10 Ago 2019
This does not work! Motor Shield V1 requires legacy Matlab's Arduino support package and can't be installed beside new Matlab's Arduino support package.
Madhu Govindarajan
Madhu Govindarajan il 12 Ago 2019
Adafruit Motor Shield V1 has been discontinued for a while and hence was never supported by the official MATLAB Support package. However, if you are interested here are a set of instructions that shows how to create your own custom support along with an example at the bottom of that page - https://www.mathworks.com/help/supportpkg/arduinoio/ug/custom-arduino-add-on-device-library-and-code.html
If you end up creating an add-on, please share with community using File Exchange.
Regards,
Madhu

Accedi per commentare.

Community

Più risposte nel  Power Electronics Control

Categorie

Scopri di più su Arduino Hardware in Help Center e File Exchange

Prodotti

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by