How to use the Assignment block?
2 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Hi guys,
I have been trying to replace the blocks used in the right half part of the snip shown below with the Assignment block. But I am not sure of how to use the initialisation input signal(Y0) to this block, as my input and the initialisation in this case seem to be the same.
Thanks in advance for your response.
2 Commenti
madhan ravi
il 12 Apr 2019
Modificato: madhan ravi
il 12 Apr 2019
Which is y0 ? What are you trying to do? More description needed.
Risposte (1)
Mark McBroom
il 15 Apr 2019
I thing the proper modeling pattern for this case would be an "If Subsystem" connected to two "If-Action" subsystems. If condition is true, one subsystem will be activated which will write to CW port, else other subsystem will write to ACW port. Note that for subsystem that is not active, you can configure it to either hold last value or reset.
0 Commenti
Vedere anche
Categorie
Scopri di più su Subsystems in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!