I can not get a "GUIDE" to open
3 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Pedro Guevara
il 31 Mag 2019
Commentato: Pedro Guevara
il 2 Giu 2019
Goodnight. I have the following problem. I have 2 "Guides", one called "form1" and the other "form2". The process is to press a button of the "form1" must make a series of calculations and at the end of all those calculations must open my "form2" (taking some data from my "form1"). I already tried several solcutions that I found on the internet, but I can not get my "form2" open, in fact I have not been able to create an .m file for that Guide. Please, I need your help with this. I am very new in Matlab and I still do not know much about this tool. thank you.
0 Commenti
Risposta accettata
Walter Roberson
il 31 Mag 2019
Invoke guide and tell it to create new GUI, and give it the name form2 . Put all relevant controls in it. Save it as normal, with .fig and .m file.
Inside form1, you can use
handles.data_form2_will_need = whatever;
guidata(handles);
form2_h = form2();
to get the handle of form2 in order to communicate with it.
Inside the OpenFcn for form2 you can use,
%we are inside form2 here, handles refers only to form2's handles
handles.form1_h = findobj(groot, 'tag', 'form1');
handles1 = guidata(handles.form1_h); %this is form1's handles
handles.data_form2_needs = handles1.data_form2_will_need;
guidata(hObject, handles)
3 Commenti
Walter Roberson
il 1 Giu 2019
Modificato: Walter Roberson
il 1 Giu 2019
guidata(hObject, handles);
In form2 you should put in a breakpoint at
handles.form1_h = findobj(groot, 'tag', 'form1');
and step through that, and check whether handles.form1_h is empty . If it is empty, then your form1 GUI is not really named form1 .
Più risposte (0)
Vedere anche
Categorie
Scopri di più su Migrate GUIDE Apps in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!