lookup table in simulink
15 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
bhaskar ponnana
il 23 Set 2019
Modificato: Jim Riggs
il 23 Set 2019
Hi All ,
I am new to simulink . I am trying to create a look up table with certain correction factor values . Problem that I face is that my breakpoints are not evenly spaced so when I use simulink 1D lookup table block , I get error . Any work around for this problem .
Thanks in advance
0 Commenti
Risposta accettata
Jim Riggs
il 23 Set 2019
There is no reason that non-uniform breakpoint spacing should be causing an error with the 1D interpolation function. I think that the error is from some other cause. You need to provide more information.
How are you defining the interpolation table (can you show the values)
What exact error message is being given?
2 Commenti
Jim Riggs
il 23 Set 2019
Modificato: Jim Riggs
il 23 Set 2019
OK. It's not the breakpoint spacing, but that the values are decreasing.
You can simply flip the table so that the breakpoints are increasing.
Also, the requirement for monotonicity applies ONLY to the breakpoints. The data values associated with them can be anything.
Più risposte (0)
Vedere anche
Categorie
Scopri di più su Nonlinearity in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!