Why do I get an error regarding "cl_inventor2sm.dll" or "cl_sldwks2sm.dll" when registering Simscape Multibody Link Plug-In in MATLAB R2019b?
6 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
MathWorks Support Team
il 17 Ott 2019
Modificato: MathWorks Support Team
il 18 Ott 2019
When calling "smlink_linkinv" to register the Simscape Multibody Plug-In, I see the following error:
The module "E:\MATLAB64\R2019b\bin\win64\cl_inventor2sm.dll" failed to load.
Make sure the binary is stored at the specified path or debug it to check for problems with the binary or dependent .DLL files.
The specified module could not be found.
The same error is shown when calling "smlink_linksw", but the module that fails to load is cl_sldwks2sm.dll.
Risposta accettata
MathWorks Support Team
il 28 Feb 2020
Modificato: MathWorks Support Team
il 18 Ott 2019
This error message caused by a missing DLL in the MATLAB installation.
To fix the issue, place the attached file "xerces-c_3_1.dll" into your MATLABROOT\bin\win64 folder, where MATLABROOT is the folder where MATLAB is installed.
0 Commenti
Più risposte (0)
Vedere anche
Categorie
Scopri di più su Introduction to Installation and Licensing in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!