Azzera filtri
Azzera filtri

What are "gap ports" in Simulink?

2 visualizzazioni (ultimi 30 giorni)
Zachary
Zachary il 20 Gen 2020
Commentato: Zachary il 27 Gen 2020
I am trying to convert a Subsystem to a Subsystem Reference, but I get this error message. What are "gap ports"? I can't find any mention of it on MATLAB Documentation or MATLAB Answers.
Capture.PNG

Risposta accettata

Payas Bahade
Payas Bahade il 24 Gen 2020
Hi Zachary,
This is a known issue and the error is due to the number of port handles and the number of port blocks inside the Subsystem being unequal.
To get rid of the error, both port handles and port blocks have to be equal in number.
Hope this helps!
  1 Commento
Zachary
Zachary il 27 Gen 2020
In the end, I was unable find the mismatch between port handles and number of port blocks. Instead of using the toolstrip UI conversion, I manually copied the contents into a new Blank Subsystem, saved the file, and configured a new Subsystem Reference block to point to this new file.
If this post is viewed by others, I might have been able to troubleshoot by reading the block's 'PortHandles' and 'Ports' properties...
port_handles = get_param(gcb,'PortHandles')
ports = get_param(gcb,'Ports')
...and altering the incorrect values with set_param, but I didn't try this so no promises.

Accedi per commentare.

Più risposte (0)

Categorie

Scopri di più su Subsystems in Help Center e File Exchange

Prodotti


Release

R2019b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by