Modify number of antennas in NR PDSCH Throughput
2 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Javier Sola morras
il 16 Apr 2020
Risposto: Sriram Tadavarty
il 27 Apr 2020
I want to modify the number of antennas to perform the NR PDSCH Throughput simulation. But it is wrong to change only the value of
- simParameters.NTxAnts = 8;
- simParameters.NumCW = 2;
- simParameters.PDSCH.TargetCodeRate = [490 490]./1024;
- simParameters.PDSCH.Modulation = {'16QAM','16QAM'};
- simParameters.NRxAnts = 8;
0 Commenti
Risposta accettata
Sriram Tadavarty
il 27 Apr 2020
Hi Javier,
The one most important aspect is to change is the number of layers. The number of layers decide whether the number of codewords is set to 1 or 2. Though you made your simulation setup to NumCW as 2, if the NumLayers field is less than 4, it doesnt affect.
When the number of layers is greater than 4, there will be two codewords. When the number of layers is less than or equal to 1, there will be single codeword.
So the update required is;
simParameters.PDSCH.NLayers = 5; % Any value greater than 4 and less than or equal to 8, to perform two codewords simulation
Hope this helps.
Regards,
Sriram
0 Commenti
Più risposte (0)
Vedere anche
Categorie
Scopri di più su Modeling Basics in Help Center e File Exchange
Prodotti
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!