I am trying to use the Sgolayfilt function on 4 FFTs I have been doing to obtain a signal with less noise. However, I have a feeling I have either not set-up the sgolayfilt function properly (a little confused regarding how to implement the polynom order and the number of points, aside from trial and error), or I should be using a different function altogether. I have attached my code (very rough and probably not very elegant, but that's ok) for some insights. My issue is around B_221 and B_112 (Figure 1 and Figure 2), that look very much identical, but have very different FFTs (P1_221, and P1_112). I suspect perhaps a different filter should be used instead, and this is why I post the message on this forum. Any assistance from a knowledgable audience would really help.

Sgolayfilt - FFT smoothing or oversmoothing.

16 Lug 2020

0 Risposte

5 Visualizzazioni (30 giorni)

0 voti

I am trying to use the Sgolayfilt function on 4 FFTs I have been doing to obtain a signal with less noise.

However, I have a feeling I have either not set-up the sgolayfilt function properly (a little confused regarding how to implement the polynom order and the number of points, aside from trial and error), or I should be using a different function altogether.

I have attached my code (very rough and probably not very elegant, but that's ok) for some insights.

My issue is around B_221 and B_112 (Figure 1 and Figure 2), that look very much identical, but have very different FFTs (P1_221, and P1_112). I suspect perhaps a different filter should be used instead, and this is why I post the message on this forum.
Any assistance from a knowledgable audience would really help.