Extremely slow compilation time in referenced model (Simulink)
55 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
I have a Simulink model (model1) which has a model reference to model2.
Model2 compilation time (checked with sldiagnostics) is pretty fast, takes 10s or so. However, when I compile model1, the compilation times takes more than 3 minutes, and according to sldiagnostics, the only step that's taking too long is exactly this:
Cstat28: 190.56 seconds -- Check And Compile Model Reference Normal Modes
which is the compilation of the referenced model (model2).
How's this possible? What could I do to alleviate this, as a 3-minute compilation time is a huge hindrance for my test environment.
6 Commenti
Mark Hiteshew
il 5 Nov 2021
I have this same issue. I have a lot of model references and it takes a while to 'update' them before starting to run the model, even if I haven't changed anything in the model references. It's rather annoying
D D
il 19 Giu 2023
I also have same problem. I have a lot of model references and it takes a while to compule them when starting to run the model, even if I haven't changed anything in the model references. Please share if any solution is identified..
Risposte (1)
Jesús Zambrano
il 8 Set 2020
Try running the top-level model in Accelerator or Rapid Accelerator mode.
Here are a few tips when using the Accelerator and Rapid Accelerator mode:
- Avoid blocks that do not support code generation. They run in interpreted mode and can slowdown your model.
- Try switching the Compiler Optimization Level from faster build to faster run.
- For maximum speed, start your simulation using the sim command when using these modes.
5 Commenti
D D
il 19 Giu 2023
I also have same problem. I have a lot of model references and it takes a while to compule them when starting to run the model, even if I haven't changed anything in the model references. Please share if any solution is identified..
Eric Racicot
il 20 Giu 2023
I run optimizer for a patch antenna... showing Building Model for about 15 minutes and nothing change... I look computer task manager and mathlab using less than 2% of processor. Why is so long?
Vedere anche
Categorie
Scopri di più su Configure and View Diagnostics in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!