I need to create a visual dashboard on Simulink

Hello everyone, I have the following matlab code. It runs perfectly and I receive no error codes and does what I want it to do.

load('ThreeClasses')

for i = 1:size(TestPoints,1)

X=TestPoints(i,2);

Y=TestPoints(i,3);

Delta1=log(P1)-0.5*mu1*inv(Sw)*mu1'+mu1*inv(Sw)*[X;Y];

Delta2=log(P2)-0.5*mu2*inv(Sw)*mu2'+mu2*inv(Sw)*[X;Y];

Delta3=log(P3)-0.5*mu3*inv(Sw)*mu3'+mu3*inv(Sw)*[X;Y];

pause(1)

clc

% The first initial d1 = 0 because there is no previous distance. It's the

% first one. The next d1 will have the previous value of d2.

try

d1;

catch

d1=0;

end

% The first initial t1 = 0 because there is no previous time. It's the

% first one. The next t1 will have the previous value of t2.

try

t1;

catch

t1=0;

end

%

d2=abs(B32 + A32*[X;Y]);sqrt(A32(1,1)^2+A32(1,2)^2);

t2=TestPoints(i,1); %time in seconds for the particular datapoint

%

%Calculating the Remaining Useful Life

RUL = d2*(t2-t1)/(d1-d2); % Units are in seconds

RUL_days=RUL/86400; % Units are in days

%

d1=d2;

t1=t2;

pause(1)

end

My problem now is that I want to show the (RUL) in simulink. I do have some experience in Simulink but all the simuluations I have done have been simple like second order mass-spring-dampener systems. My current matlab code calculates RUL based on the row that is being evaluated from the ThreeClasses file. This file is a (nx3) matrix. What my code does is it calculates the first RUL, pauses for 1 second then calculates the next RUL and so on and so on until based on the number of rows.

I want to do the same thing in Simulink.

I want to create like a block diagram or something; when I click run, it calculates the first RUL, pauses for 1 second, then shows the next one and so on and so on until all RUL's have been calculated and shown in Simulink.

Any help or suggestions are greatly appreciated.