Hello, I was trying to generate code for TI DSP form the simulink model. It is a 3 phase pwm rectifier. But the code I generated doesn't look like that I can use for the DSP. My question is : # Do I need to make changes to my model in order to generate code? # Can I generate the required code for the DSP by only using Simulink or do I need to connect it to the real DSP board? # There is hardware implemetation in the parameter configuration dialogue and also a system preference block. Both of them can be used to chose a hardware. Which one should I use? Thank you so much.

generating code from embedded coder

Chenyang Zhang

15 Feb 2013

0 Risposte

Aggiornato 20 Ago 2021

1 Visualizzazione (30 giorni)

Follow Question

Informazioni

Questa domanda è chiusa. Riaprila per modificarla o per rispondere.

Mostra commenti meno recenti

0 voti

Hello, I was trying to generate code for TI DSP form the simulink model. It is a 3 phase pwm rectifier. But the code I generated doesn't look like that I can use for the DSP. My question is :

Do I need to make changes to my model in order to generate code?
Can I generate the required code for the DSP by only using Simulink or do I need to connect it to the real DSP board?
There is hardware implemetation in the parameter configuration dialogue and also a system preference block. Both of them can be used to chose a hardware. Which one should I use?

Thank you so much.