How do I measure the output of a solar PV array in Simulink
14 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Hi. I am very new to matlab and simulink and i am would like to know how can i measure the output voltage and current of a solar PV array?
I have already given a constant input irradiance of 1000 W/m^2 via the ps converter into the PV array (subsystem box) but would now like to know where to go from there?
Any suggestions or help will be greatly appreciated :)
2 Commenti
Saqib Saeed
il 30 Set 2017
you can use current measurement in series and voltage measurement parallel block.
vignan mullapudi
il 2 Mag 2018
Excuse me sir, I had used inbuilt PV array, in the block parameters i got the plots of I-V and P-V. But I would like to measure the output voltage with respect to time such that I had used voltage measurement block. While I measured i got 0 volts orele a very small in decimals (e.g., 0.88) i put load as Vmp/Imp
Would please suggest me what should I do
Regards
Risposte (1)
HARITHA M.S
il 31 Gen 2018
Modificato: HARITHA M.S
il 31 Gen 2018
PS converter is used to convert unitless signal to physical signal suitable for simpowersystem. Below attached file will help you.
0 Commenti
Vedere anche
Categorie
Scopri di più su Electrical Block Libraries in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!