Opening txt files using fopen, and fgetl in my executable program is bugging out. Any ideas?

When i run the program just straight out of matlab it works fine. In the program there are many occasions where i use fgetl, and fopen. For some reason, my code seems to be bugging out at these locations when i try and run the same program as a console application (compiled matlab .exe file). I would just like to know if there is a way around this problem or something?

[Leslie Smith]

the same for me too, no answers?

[Rik]

Without explicit step to reproduce this, it is difficult to offer any advice other than: limit file interactions to a single part of your code.

[Leslie Smith]

found my problem, the fopen (before the fgetl) referred to a file that was not included in the 'files required for your application to run' section.