Why do i receive an error message when working on PIL simulation for F28388D?

Hi,

I am working on a Processor-in-the-loop simulation for F28388D. I configured all of the parameters as far as I know. But when the compiling is the end, I receive an error message about communication. I have shared all of the configuration steps below that I have captured. If you solve my problem, I will be happy about that.

Thank you.

Sincerely,

1) Hardware Board

2-a) Hardware Implementation Pane (Build Options)

2-b) Hardware Implementation Pane (SCI-A)

2-c) Hardware Implementation Pane (Extarnal Mode)

3) Serial Port on my PC

4) Controller block for PIL that I created using "rtwbuild".

5) I have changed the controller block with the controller1 PIL Block.

6) I couldn't set the Board Name.

7) Finally, I've tried to fix the problem. But I have received the same error message over and over.

8) Besides, here is my controlCARD's design and switch positions.

Answer 1

[cagdas hisar]

ok , i solved the problem alone.