How to get the desired frequency in simplified synchronous machine?
2 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Hello,
when i simulate the model using simplified synchronous machine the output frequency is not proper. The parameters which i am supposed to use to get a frequency of 400Hz is N=6000(the input to the model is 628rad/s), pole pairs=4. when i give this parameter i don't get a freq of 400Hz, why is this? is there any other parameters that i have to change? if so please help me.
8 Commenti
syed zia
il 23 Mag 2013
I also need da same thing ,want to measure the frequency...and its variation after increasing load.........plz help me tnx....
Risposta accettata
John Doe
il 6 Mag 2013
Modificato: John Doe
il 6 Mag 2013
The electrical frequency is, as stated in the comments:
f_elec = poles * f_mec / 2
I was wondering what you were doing, because I can't see where you get in trouble. In a synchronous machine, the output frequency is only a function of the number of poles, and the rotor frequency, nothing else.
Since I don't know how you achieved 0.153Hz, I asked to see your model, so that I could try to figure out where your error is.
Thus, the answer to your question: "Is there any other parameters that i have to change?" is No, nothing else must be changed.
Best of luck!
0 Commenti
Più risposte (0)
Vedere anche
Categorie
Scopri di più su Switches and Breakers in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!