Info
Questa domanda è chiusa. Riaprila per modificarla o per rispondere.
help in calculation with given code
2 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
hi,all i have unipolar stepper motor with step angle 1.8 i use the following code to rotate it in full step mode (4 sequence)
mov a,#66h
mov dptr,#portc
mov r7,#4h
N91:mov r6,#29h
begin3:movx @dptr,a
rr a
acall delay2
djnz r6,begin3
djnz r7,N91
where delay2 represent delay=23.911ms how i can calculate the following parameters:
(i know resolution=360/1.8=200 step/revolution)
- pulse frquency resolution(n)=1.8*f/360=?where f:stepping frquency(pulse rate)=?
- motor speed?
- number of pulses required to move shaft through 54 degree?
- revolution/minute (rpm)?
- steps/second(pulse/second)=(rpm*200)/60=?
how i can know number of phases and number of stator or rotor teeth if i have no data sheet i take the motor from dot matrix printer thanks in advance for help, suggestion,guiding
0 Commenti
Risposte (0)
Questa domanda è chiusa.
Vedere anche
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!