Alternately zooming and editing a figure

6 views (last 30 days)
Has anyone found a solution to the problem that the edit model and zoom mode are mutually exclusive and buttons far apart? I spend about half my time zooming in and out and then going into edit mode and back into zoom mode. The edit button is all the way over on the left, and the zoom button is over on the right. I tried to set up a keyboard shortcut for switching edit-off-zoom-on, and the reverse but couldn't figure out how.

Accepted Answer

Pratheek Punchathody
Pratheek Punchathody on 31 Mar 2021
Edited: Pratheek Punchathody on 31 Mar 2021
As per my understanding, you are using the Zoom tool in the axes bar of the figure window and Edit menu from the menu alternatively. One work around to reduce the time of work during the switch between these two options is to enable the property inspector.
Following steps would help you to enable this,
View>Property inspector
By enabling this Property inspector will be populated along side of the Figure window.
Configuring and layouting the window according to the need will help you in minimizing the time to navigate between the edit and zoom mode.
Hope this helps..!
  1 Comment
Todd Welti
Todd Welti on 31 Mar 2021
Yes, that is a possible solution. I need to familiarized myself more with that wind so I can find stuff quicker.

Sign in to comment.

More Answers (0)

Products


Release

R2020a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by