Azzera filtri
Azzera filtri

cannot connect to ZYNQ hardware using MATLAB/simulink

15 visualizzazioni (ultimi 30 giorni)
Hi,
I'm trying to run simulink example "Transmit and Receive a Tone Using Xilinx RFSoC Device - Part 2 Deployment". I'm using ZYNQ UlltraScale+ ZCU111 RFSOC. Simulink continuously prompts an issue of unable to connect to IP address 169.254.0.2 although the same is written in SD card. I tried to connect it alot of times by continuous reboots. Out of so many tries it gets connected but again fails at Load design step. I've attached snaps of errors, sd card content (firmware), vivado binaries. I performed the same procedure on the other board and exampe ran succesfully. I have also attached SD card content for board too in folder SD card 1. Does anyone have any idea what can be the possible issue?

Risposta accettata

Urmila Rajpurohith
Urmila Rajpurohith il 29 Mar 2021
Spostato: Stefanie Schwarz il 22 Set 2022
Hi
This might be because of the SSH connection which could not be established via Ethernet.
Try the troubleshooting steps mentioned in the below link where you posted your query:
Hope this helps!

Più risposte (0)

Tag

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by