Simulink: Run model again without recompiling
29 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Hello!
How do I set up my model so that it only needs to be compiled once and can then be run multiple times? My model takes about 1-2 minutes for compiling and initializing, and then only a couple of seconds to run the simulation, so simply using the previously generated compilation should bring much better performance...
0 Commenti
Risposte (2)
Kaustubha Govind
il 12 Giu 2013
Would you perhaps want to consider referencing your model as part of another test harness model (see Model Reference). If the referenced model is setup to run in Accelerator mode, the C-code for it is only generated once and won't need to be re-compiled unless there are structural or dependency changes.
0 Commenti
Vedere anche
Categorie
Scopri di più su Component-Based Modeling in Help Center e File Exchange
Prodotti
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!