How to implement angular range constraints in SimMechanics 2nd Generation?
1 visualizzazione (ultimi 30 giorni)
Mostra commenti meno recenti
Hi
I'm trying to use SimMechanics 2nd Gen to model a revolute joint with angular ranges of +-90 degrees.
SimMechanics has a fixed angle constraint, but I would like to move my system till it reaches the limits and only then have the constraint engage.
Can you please advise how I can do this? I've successfully implemented this using the SimScape foundation library but I cannot correctly interface this to SimMechanics. The joint goes past the angular limits.
Any help would be appreciated.
Regards
Amir
0 Commenti
Risposte (1)
Javaria Chiragh
il 24 Mag 2014
There is an Angle Constraint block in Simscape/SimMechanics/2ndgeneration/Constraints but I dont know how to use it...!!
0 Commenti
Vedere anche
Categorie
Scopri di più su Assembly in Help Center e File Exchange
Prodotti
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!