photo

Ronny Landsverk


Last seen: 3 mesi fa |  Attivo dal 2019

Followers: 0   Following: 0

Programming Languages:
Python, C++, C, C#, VHDL
Spoken Languages:
English

Statistica

All
  • Solver
  • First Answer

Visualizza badge

Feeds

Visto da

Domanda


The RL-Agent's cumulative reward keeps overflowing
Adapting the 'rlwatertank' example, my cumulative reward keeps overflowing. The original example has a 'StopTrainingValue' of 8...

oltre un anno fa | 1 risposta | 0

1

risposta

Risposto
TI F28069M Launchpad with BOOSTXL-DRV8305 inverter: closed-loop speed control via host model not working properly.
The reason for the ill behaviour was due to rotor alignment. Even though I ran the encoder position offset estimation program, ...

circa 2 anni fa | 0

Domanda


TI F28069M Launchpad with BOOSTXL-DRV8305 inverter: which examples are valid ?
The Motor Control Blockset has some good examples, but only a few are valid for any particular set of hardware. E.g. I have a T...

circa 2 anni fa | 1 risposta | 0

1

risposta

Domanda


TI F28069M Launchpad with BOOSTXL-DRV8305 inverter: closed-loop speed control via host model not working properly.
I'm "getting started" with MATLAB Motor Control Blockset and I have the F28069M LaunchpadXL with a BOOSTXL-DRV8305 inverter and ...

circa 2 anni fa | 1 risposta | 0

1

risposta

Risolto


Times 2 - START HERE
Try out this test problem first. Given the variable x as your input, multiply it by two and put the result in y. Examples:...

oltre 3 anni fa

Domanda


Iterative learning - Simulink
The figure shows a conceptual block diagram of an iterative learning algorithm, for the 'th iteration. The process model is a...

oltre 4 anni fa | 0 risposte | 0

0

risposte

Risposto
how can i remove an element from a matrix
If you want a representation of an empty element, use NaN (not a number). A(2,2) = NaN;

oltre 5 anni fa | 1

Domanda


Construction of block diagram with multiple summing junction and disturbance for simulation with lsim
Please consider that I want to know how to simulate the system using the lsim command, and not in Simulink The block diagram ...

oltre 5 anni fa | 0 risposte | 0

0

risposte

Domanda


How to switch between toolboxes. Can we hide a toolbox temporarily ?
I have MATLAB R2018b with symbolic math toolbox, and Maple 2017 release 3 installed. The Maple installation asked to use a Mapl...

oltre 5 anni fa | 0 risposte | 0

0

risposte