Statistica
RANK
176.292
of 300.771
REPUTAZIONE
0
CONTRIBUTI
3 Domande
1 Risposta
ACCETTAZIONE DELLE RISPOSTE
0.0%
VOTI RICEVUTI
0
RANK
of 170.969
CONTRIBUTI
0 Problemi
0 Soluzioni
PUNTEGGIO
0
NUMERO DI BADGE
0
CONTRIBUTI
0 Post
CONTRIBUTI
0 Pubblico Canali
VALUTAZIONE MEDIA
CONTRIBUTI
0 Punti principali
NUMERO MEDIO DI LIKE
Feeds
Risposto
Repeating sequence Error ?
Use Scope of Simulink> Commonly used block , not use time scope for display
Repeating sequence Error ?
Use Scope of Simulink> Commonly used block , not use time scope for display
quasi 7 anni fa | 0
Domanda
How can i get the exact frequency of generated waveform on stm32f407. When I use case A , burn it on stm , i get exact frequency 1kHz(Same as that of input pulse) . But when i burn both Cases A and B the frequency gets reduced to 800Hz .
quasi 7 anni fa | 0 risposte | 0
0
risposteDomanda
Hw can I controll rise and fall edge of a pulse according to my own requirement for particular time and then applying required pattern on that holdon interval > As given below
quasi 7 anni fa | 0 risposte | 0
0
risposteDomanda
How can i display the analog signal from stm32f4xx to the scope of matlab simulink
Sir, I'm using stm32f401 controller , i want to display the sine wave (with DC offset) of signal generatore in the matlab scop...
quasi 7 anni fa | 0 risposte | 0
