ghulam murtaza

Last seen: 2 mesi fa | Attivo dal 2019

Followers: 0 Following: 0

Messaggio

Statistica

Visualizza badge

Feeds

Risposto
Repeating sequence Error ?
Use Scope of Simulink> Commonly used block , not use time scope for display

oltre 5 anni fa | 0

Domanda

How can i get the exact frequency of generated waveform on stm32f407. When I use case A , burn it on stm , i get exact frequency 1kHz(Same as that of input pulse) . But when i burn both Cases A and B the frequency gets reduced to 800Hz .

oltre 5 anni fa | 0 risposte | 0

0

risposte

Domanda

Hw can I controll rise and fall edge of a pulse according to my own requirement for particular time and then applying required pattern on that holdon interval > As given below

oltre 5 anni fa | 0 risposte | 0

0

risposte

Domanda

How can i display the analog signal from stm32f4xx to the scope of matlab simulink
Sir, I'm using stm32f401 controller , i want to display the sine wave (with DC offset) of signal generatore in the matlab scop...

oltre 5 anni fa | 0 risposte | 0

0

risposte