Statistica
RANK
89.327
of 300.840
REPUTAZIONE
0
CONTRIBUTI
2 Domande
3 Risposte
ACCETTAZIONE DELLE RISPOSTE
50.0%
VOTI RICEVUTI
0
RANK
of 171.238
CONTRIBUTI
0 Problemi
0 Soluzioni
PUNTEGGIO
0
NUMERO DI BADGE
0
CONTRIBUTI
0 Post
CONTRIBUTI
0 Pubblico Canali
VALUTAZIONE MEDIA
CONTRIBUTI
0 Punti principali
NUMERO MEDIO DI LIKE
Feeds
Risposto
Parameter identification with nlgreyest
I was able to ge the system identification that matches the CFD response but I would like to set some comtraints on the maximum ...
Parameter identification with nlgreyest
I was able to ge the system identification that matches the CFD response but I would like to set some comtraints on the maximum ...
oltre 6 anni fa | 0
Risposto
Parameter identification with nlgreyest
clc clear all % i want to use this script to estimate damping fprintf('ensure all PRT parameters are correct\n') xt=0.1; %...
Parameter identification with nlgreyest
clc clear all % i want to use this script to estimate damping fprintf('ensure all PRT parameters are correct\n') xt=0.1; %...
oltre 6 anni fa | 0
Domanda
Parameter identification with nlgreyest
I have a non-linear model I want to fit into an available to identify system parameters. I have used nlgreyest but the result is...
oltre 6 anni fa | 3 risposte | 0
3
risposteRisposto
Running Simulink model in a loop
I have found where the problem is. Very basic mistake. I wrote i=length(omega) and not i=1:length(omega). Thanks for responding...
Running Simulink model in a loop
I have found where the problem is. Very basic mistake. I wrote i=length(omega) and not i=1:length(omega). Thanks for responding...
oltre 6 anni fa | 0
Domanda
Running Simulink model in a loop
I want to run a simulink model in a loop and store the output for analysis. However, I noticed that it is the result of the las...
oltre 6 anni fa | 2 risposte | 0
